Whenever there’s been a brief interlude without rain (not often lately!) and I’ve been home/free, I’ve grabbed the opportunity to make progress – even in tiny little incremental steps – on the shed roof.
The four panels that I used to do the roof were more than adequate lengthwise, giving enough coverage to project at each end (front and back, I suppose?). But the 8 foot length boards were only just big enough to reach across the width of the roof.
Also, the shed was a bit out of square. So once the roofing boards were up and in place, they didn’t present straight/flush edges along the longer axis of the whole roof.
This meant I had to trim them, to get a straight line. And then somehow add long strips. Fortunately the off it’s from the front and back were just enough for the job. I had to cut them in half lengthwise. Bit of a faff!
But I did it. And on one day last week – Tuesday perhaps? – I did the higher side. And today I did the lower side. It wasn’t easy! And I didn’t do a perfect job. Far, far from it!
But hopefully it’s adequate? At least now the roof project out over the shed walls on every face. I’ll prob’ want to mix some sawdust and wood-glue filler, and fill some of the gaps between panels. And I’ve tried to find screws long enough to go through the whole width of the add-on boards.
Anyway, a couple more small steps towards getting the shed shop shape, and ready to move all my tools out of the previous workshop. The latter will become our art studio. With room to paint. A small etching press, and – if I can get it working – a kiln!
So much to do!